This process is called Exclusion.īoth processes are initiated by the primary controller of the Z-Wave network. To be added to an existing wireless network to communicate with the devices of this network.ĭevices can also be removed from a network. On factory default the device does not belong to any Z-Wave network. The product, the voltage network has to be switched off and ensured against re-switching. Installation guidelines/norms may do works with mains power. Safety Warning for Mains Powered DevicesĪTTENTION: only authorized technicians under consideration of the country-specific Short press the product’s Action button that you can find on the product"s housing. Procedure should only be used when the primary controller is inoperable. This device also allows to be reset without any involvement of a Z-Wave controller. Every Z-WaveĬontroller is able to perform this operation however it is recommended to use the primaryĬontroller of the previous network to make sure the very device is excluded properlyįrom this network. Performing an Exclusion operation as described below in the manual. Please make sure to reset the device into factory default. In order to include (add) a Z-Wave device to a network it must be in factory default
#AEON LABS Z STICK FIRMWARE UPDATE MANUAL#
Please read the user manual before installing the product. The Smart Switch 6 is also a security Z-wave device and supports Over The Air (OTA) feature for the products firmware upgrade. You can configure its indication colour according to your favour. Its surface has a Smart RGB LED, which can be used for indicating the output load status or strength of the wireless signal.
In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status. It can report immediate wattage consumption or kWh energy usage over a period of time. please referĪeotec Smart Switch 6 is a low-cost Z-Wave Switch plug-in module specifically used to enable Z-Wave command and control (on/off) of any plug-in tool. Otherwise it will automatically turn into a lower level of security to maintainįor more information about Z-Wave technology, devices, white papers etc. Secure as long as this device provides the same or a higher level of security. If a device supports secure communication it will communicate with other devices This device and every other certified Z-Wave device can be used together with any otherĬertified Z-Wave device regardless of brand and origin as long as both are suited for the ( meshed network) in case the receiver is not in direct wireless range of the Z-Wave ensures a reliable communication by reconfirming every message ( two-wayĬommunication) and every mains powered node can act as a repeater for other nodes Thisĭevice is suited for use in the region mentioned in the Quickstart section. Z-Wave is the international wireless protocol for communication in the Smart Home. Follow the disposal instructions.ĭo not dispose of electronic equipment or batteries in a fire or near open heat sources.
Use this equipment only for its intended purpose. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
0 kommentar(er)
